Butt-ended circlip pliers

Butt-Ended Circlip Pliers

A butt-ended circlip plier is a specialised tool used for installing and removing circlips, also known as retaining rings. The key features of a butt-ended circlip plier are:

Straight, pointed jaws that can fit into the small gap between the circlip and the groove it sits in4

Jaws that are angled at 90 degrees for easier access in tight spaces

PVC-coated handles for a comfortable, non-slip grip

Specific size ranges, such as 30mm-100mm for external circlips

Butt-ended circlip pliers are used for the following purposes:

Removing and installing external circlips that hold components like bearings, gears, and pulleys in place
Fitting into tight spaces where the circlip is installed
Providing a secure grip on the circlip to allow it to be expanded or compressed for removal or installation

To use a butt-ended circlip plier, the pointed jaws are inserted into the gap between the circlip and the groove. The plier is then squeezed to expand or compress the circlip, allowing it to be removed or installed. The angled jaws and PVC-coated handles provide leverage and comfort during this process. Butt-ended circlip pliers are commonly used in automotive repair, machinery maintenance, and other applications where circlips are used to secure components.

Frequently Asked Questions

How much weight can a heavy duty jack stand hold?

Capacity varies by model and is stated on each product page. Check the rating for the specific stand you are using, and always work in a matched pair.

Do I need 3 tonne or 6 tonne jack stands?

Work from the weight that will sit on the pair of stands rather than the vehicle’s total weight, then allow a margin above that figure.

Should jack stands always be used in pairs?

Yes. A matched pair set to the same height spreads the load evenly and keeps the vehicle level while you work.

Can a vehicle be left on jack stands overnight?

Stands are made to hold a static load, so a longer job is fine on level, solid ground. Check the vehicle is still sitting square each time you return to it.

What working height do I need for a truck or 4WD?

Measure from the ground to your support point with the wheels off. The tallest 3010H and 3010V models reach 1077 mm and 1090 mm respectively.

Browse the full range of Beta Tools jack stands, or talk to the UNIPAC team about matching stands to the vehicles you work on.